تمامی کالا ها و خدمات این فروشگاه ، حسب مورد دارای مجوز های لازم از مراجع مربوطه می باشند و فعالیت های این سایت تابع قوانین و مقررات جمهوری اسلامی ایران است .
توجه: بدلیل نوسانات شدید قیمت بازار لطفا قبل از پرداخت اینترنتی تصویر فاکتور خود را از طریق واتس آپ به شماره +98 905 586 3749 ارسال نمایید.
خرید سریع
| توضیحات |
This is a breakout board for the SP3485 RS-485 transceiver IC, which will convert a UART serial stream to RS-485. The SP3485 is a half-duplex transceiver, so it can only communicate one way at a time, but it can reach transmission speeds of up to 10Mbps. This board requires a very low amount of power and can operate from a single +3.3VDC supply.
This breakout board includes the SP3485 RS-485 transceiver, filter capacitor, and other components shown on the schematic. We’ve broken out the RS-485 output to three different connections: (1) an RJ-45 connector, (2) a 3-pin 3.55mm screw terminal, and (3) a 3-pin 0.1" pitch header; none of these output connectors come populated.
|
| Fully equipped with SP3485 RS-485 transceiver and supporting components |
| Operates from a single +3.3V supply |
| Interoperable with +5.0V logic |
| RS-485 input/output broken out to RJ-45 connector, 3.5mm screw terminal, and 0.1" pitch header |
| Driver/Receiver Enable connected to RTS line |
| -7V to +12V Common-Mode Input Voltage Range |
| Allows up to 32 transceivers on the serial bus |
| Driver Output Short-Circuit Protection |
| Dimensions: 0.9x1.0" |